Oldham BM25 Hazardous Area Monitor

Very High Safety Level area monitor Can be used in zone 0 rated areas 1 to 5 gases including toxic, oxygen & flammable Intelligent sensor blocks Long run time of up to 170 hours 2 logical inputs and 2 logical outputs Can be trickle charged in zone 0 locations Fully ATEX approved for zone zero use Data logging Fully ATEX certified

Continuous Protection for the Workforce from Toxic & Explosive Gases

Replacing the successful Oldham BM22+ is the new BM25 hazardous area monitor certified for use in zone zero rated areas.  With up to 170 hours continuous operation on a single charge and supplying a powerful audible alarm (103dB at 1m) and ultra-bright LED flashing beacons, the BM25 is the only stand alone toxic gas monitor your will ever need.  For protection of a workforce in a confined space or work area, the BM25 can even be run off trickle charge (via a zener barrier) in the hazardous area providing round-the-clock protection of a wide area.

Up to five sensors can be installed in the BM25 covering a wide range of toxic gases, as well as %LEL detection of explosive gases plus oxygen deficiency, giving total workforce protection.  Units can be 'connected' together to give a safety perimeter and a manual call point can be added allowing the entire network to be alarmed together in an emergency situation.

These units are full waterproof and designed to be left in the harshest environments.  A stand is available to raise the unit off the ground should monitoring at floor level not be appropriate.

Download a full specification (pdf)

For more information, please contact Technical Sales who would be delighted to discuss your needs