![[]](/images/flagBarEnd.jpg)
Rapidox 1100Z
Process Zirconia Oxygen Gas Analyser
Bench mounted zirconia oxygen analyser for low ppm to 100% oxygen analysis. With internal sampling pump and pressure correction. Suitable for all inert gases such as Ar, N2, CO2, as a well as air and O2 measurements.
Rapidox 1100Z Zirconia Oxygen Gas Analyser
The Rapidox 1100Z oxygen analyser allows fast and accurate oxygen analysis over the range 1ppm to 100% O2. The analyser provides continuous on-line oxygen analysis, with a typical response time less than 5 seconds for a 90% response to a step change in gas compositions.
At the heart of the Rapidox 1100Z is a zirconia oxygen sensor that needs to be heated to 650°C before it will conduct oxygen ions. The analyser supplies heat to the sensor, which is controlled very accurately by a regulated power supply incorporated in the instrument. An internal pressure sensor compensates for small changes in gas pressure to keep the readings stable.
The analyser contains a powerful diaphragm pump that draws a gas sample at a flow rate set by the user between zero and 1.2 litres per minute. An on-board pressure sensor compensates for any pressure fluctuations in the sample gas. Alternatively the pump can be independently switched off and operated under flowing gas conditions.
The analyser includes two fully programmable alarm circuits (volt free contacts), programmable analogue outputs (0-10V and 4-20mA), easy calibration (using 2 or 3 user selectable gases), RS232 / RS485 communications and a full set of communications / data-logging software.
Rapidox 1100Z Testimonials
“I have been using a Rapidox 1100Z system for many years....This system works perfectly in a whole range of O2 experiments. Moreover, I like its easy-to-use software and its good integrability in a more complex virtual lab programmed with LabVIEW” (Catalonia Institute for Energy Research-IREC)
If you would like to purchase the Rapidox 1100Z or have further questions please call technical sales on:
+44 (0)1480 462142
Rapidox 1100Z Front Panel, click to enlarge
Rapidox 1100Z Rear Panel, click to enlarge
Replacement Internal Oxygen Sensor
Portable battery powered printer
Thermal mains powered printer
Peli-Case with bespoke custom insert for heavy duty transportation
Specialist filters used to remove all water from gases under analysis
Specialist filters used to remove a large quantity of water from gases under analysis
Connects the Rapidox 1100Z to computers without a serial port
Replacement in-line sample filters (pack of 5)